Hi everyone! I was wondering if you guys know of a way to remove the rear seat mount that is used for the 50/50 split leather seats. Or if you guys have a solution to mounting the seats into place. My car came with the one piece bench seat so it does not have this mount. I tried to remove it at the salvage yard but no luck :( Thanks in advance.

Drill the spot welds out. See the little circles around the mount? Drill there.

Originally posted by freelancefool
Drill the spot welds out. See the little circles around the mount? Drill there.

No.

It wont come out right. New is 8 bucks. Much easier.

I did this to my RS.

Look in CAPS. You can order that from the dealer for like 8 bucks. Then just weld in ans you are good to go.

I thought I had it in the wiki, but cannot find it.

Thank you. In case people wanted to know, it was under floor category in caps. It was PNC 75119Z. Part number MR296166.

Originally posted by jrok408
Thank you. In case people wanted to know, it was under floor category in caps. It was PNC 75119Z. Part number MR296166.

Yep! There is a wiki post I put in about it somewhere. Couldnt find it the other day ans was in the middle of something or I would have gotten you the PN.