Ok here you go. I finished it friday night but i just got around to uploading the pics.

This is right after i taped off the area i was going to cut. It helps a lot because if your bit jumps while yor sanding it just cuts the tape and not your hood.


And after i got done cutting the holes for the pins. The next pic gives you a better look at where i mounted the actual pin. I had to remove the hood prop to mount the pin which i didn't like.



It took me a good 25-30 min to get the pins and everything to line up perfect because i didn't want to put any pressure on the hood when they were latched.


And the finished product.