Go back to previous topic |
Forum name | 4G63 Tech |
Topic subject | Help with axle removal |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=67&topic_id=7649 |
7649, Help with axle removal Posted by RST95eclipse, Dec-31-69 06:00 PM
I'm attempting to remove my axles. I removed the head to have it sent off to be built along with my 6 bolt block. Currently the car is sitting with the 7 bolt block, tranny, and transfer case, etc. I've been trying to get the drivers side axle out. I've banged on the bearing housing with a rubber mallet, hard plastic mallet, framing hammer, and a 5lb hammer. Nothing. The axle rotates (as much as the tranny allows it to - very little). I had a Honda guy look at it, and he stated that his "just slide right out."
Can anyone help my troubles?
|
7650, RE: Help with axle removal Posted by dmt111701, Dec-31-69 06:00 PM
use some pb blaster where it joins the hub. let it soak. then spray some more.
|
7651, RE: Help with axle removal Posted by DSMxTSi, Dec-31-69 06:00 PM
Originally posted by RST95eclipse I had a Honda guy look at it, and he stated that his "just slide right out." Can anyone help my troubles?
Yeah, don't let Honduh guys help out with DSMs! :D
Maybe you've already tried this, but you really need to get in there with a large prybar where the axle slides into the tranny.
|
7652, RE: Help with axle removal Posted by RST95eclipse, Dec-31-69 06:00 PM
I will try both. Thank you very much guys. Do you think it's being held up at the tranny or at the axle bearing?
|
7653, RE: Help with axle removal Posted by DSMxTSi, Dec-31-69 06:00 PM
There's a clip on the spline where the axle slides into the tranny, sometimes it's a bitch to break that free. Sometimes it comes out easily. Did you unbolt the carrier bearing from the block?
|
7654, RE: Help with axle removal Posted by Jeff_99gs, Dec-31-69 06:00 PM
Originally posted by DSMxTSi There's a clip on the spline where the axle slides into the tranny, sometimes it's a bitch to break that free. Sometimes it comes out easily. Did you unbolt the carrier bearing from the block?
I came here to say this.
|
7655, RE: Help with axle removal Posted by DSMxTSi, Dec-31-69 06:00 PM
Originally posted by Jeff_99gsOriginally posted by DSMxTSi There's a clip on the spline where the axle slides into the tranny, sometimes it's a bitch to break that free. Sometimes it comes out easily. Did you unbolt the carrier bearing from the block? I came here to say this.
Great minds think alike, huh?! j/k
|
7656, RE: Help with axle removal Posted by RST95eclipse, Dec-31-69 06:00 PM
I ended up unbolting the bearing housing bracket thing. Came out just fine. Now my problem is getting it through the wishbone thing inside the suspension. :shrug
|