| Go back to previous topic | | Forum name | 4G63 Tech | | Topic subject | 6 bolt swap complete, engine still wont start! | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i67&topic_id=10922 |
10922, 6 bolt swap complete, engine still wont start!
Posted by anotherblitzedeclipse, May-14-04 04:52 AM
Ok, I have a 95 GST and I did a 6 bolt block swap and swapped out the intake manifold, throttle body and cams and port matched it. The car has 85-90 psi in each cylinder when it is cold and hasn't even ran, is that good?
I checked for spark and it works, I can smell gas so Im sure it's getting fuel and I dont see what I could have done for it not to work. Ive messed with the CAS, swapped plugs around and it wont start for nothing! Can anybody shine some light on this?
Thanks.
|
10923, RE: 6 bolt swap complete, engine still wont start!
Posted by eclipzGST, May-14-04 07:42 AM
It's because of your ECU. You need to send me your 95 eprom unit and I'll give you my 98. :P
|
10924, RE: 6 bolt swap complete, engine still wont start!
Posted by chaye, May-14-04 10:18 AM
how did you wire up your CAS and how bout your injector trigger wires and sparkplug firing order?
So, the engine does turnover but it wont start?
|
10925, RE: 6 bolt swap complete, engine still wont start!
Posted by anotherblitzedeclipse, May-18-04 12:27 PM
got it started. It was a bad CAS. Thanks for the help and no on the ecu.
lol
|
10926, RE: 6 bolt swap complete, engine still wont start!
Posted by eclipzGST, May-18-04 05:48 PM
never hurts to try. :shrug :P
| |