I am looking for the rear lower strut bar for our cars, i cannot find it anywhere anyone have a clue?

Lemme know.

Nick

try jc whitney. i got mine from them

www.optionsauto.com

Tenzo $59

I've been eyeing this one for a while. Know where I can find a front? do I need a FL? Do they exist?

You don't need a front lower but they do exist. RRE made one on our car. I got mine for $59 plus shipping. You can get it at www.roadraceengineering.com It seems a little low to the ground, even for only being lowered 1.5 inches but there looks like there might be enough room for a 3 inch down pipe. Mine has been "custom bent" by a speed bump after I had it for about a month. It bent back towards the back of the car and it has better ground clearance and is still solid! It came with new bolts and 1 spacer, if I can find the stock bolts then I am selling it to LoudEclipse along with my rear lower one. But I do have a front upper STB made by Tenzo in RED with no decal for sale and a Rear upper in Chrome with no decal (Ebay no name brand)



Contemplating Turbo. . . . .

http://hometown.aol.com/ohshootuhh/

All Motor Beast in need of MAJOR TUNING

Perf:
KYB AGX Struts
Neuspeed Sport Springs
5 Strut Bars (2 F/U, F/L, R/U, R/L)
Sprint Front Camber Kit
$15 Rear Camber Kit
Corbin's A/F Gauge
MSD DIS-2 Ignition System
Some Regrind Cams that need High Compression (which I don't have)
Ported Intake Manifold
Ported Throttle Body
Nameless Cold Air Intake with a K&N Filter
Custom 2 1/2 inch exhaust with Dual DTM Muffler
Empty Catalytic Convertor
Energy Suspension Motor Mount inserts
Hurricane_GS Short Shifter
Symborsky Shift Kit
Clutchmasters Stage 3 Modular
225/50/16inch Wheels and Tires


Audio:
Alpine CD Head Unit
Alpine Flex4 25W X 4 for Fronts and Rears
Alpine V-12 450W X 1 for Subs
Infinity Reference Series 5 1/4 and 1 inch tweeter component systems for fronts and rears
Blaupunkt 3 way 6x9's in the rears
3 MTX 5000 10" 12 ohm subs running 4 ohms mono

BWahahaha CUSTOM BENT!!! Haha that RRE bar is a bitch, it's the lowest thing on my car. I'm thinking of custom modifying it with a welder and press tool! Haha I got stuck on a the side of a mountain road thanx to that thing and it hits the lift at school. For actual cornering functionality though it does help, it stiffen the front quite a bit and they say it feels as if you had harder motor mounts. Hehe my motor must be jumping all over the place still though because my intercooler piping keeps popping apart.

does anyone have a pic of the front/rear lower bars on the car?

I'm more concerned about the rear. I've got the Apexi dunk catback and it goes under the xmember rather than over it like my Greddy did. I'm curious as to if it'll be hitting it. thanks,