| Go back to previous topic | | Forum name | Handling/Suspension | | Topic subject | intake | | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=6&topic_id=4069 |
4069, intake
Posted by guest, Dec-31-69 06:00 PM
hello,
i have a problem... i have asked this before.. but my intake is broken off, and now it's being help up by clamps, etc. but it still shakes, so I need to get a new intake asap.. but I don't want to spend hella money on it.. although i don't want to get one that is really cheap( i.e.one that breaks off) does anyone have any good advice? Please help
|
4070, RE: intake
Posted by Thunderous_Talon, Dec-31-69 06:00 PM
Alicia, go ahead and check out www.procarparts.com
--Sean B.
"Our time is here, Our time is now, Team 2gnt."
Sponsored by New Edge Racing
http://www.newedgeracing.com
|
4071, RE: intake
Posted by guest, Dec-31-69 06:00 PM
do you think that would be a quality intake? It doesn't look bad..
|
4072, RE: intake
Posted by guest, Dec-31-69 06:00 PM
hey those altezza's look pretty nice too.. are they really hard to install?
Man, lol, I am getting way too many responses :-)
|
4073, RE: intake
Posted by Thunderous_Talon, Dec-31-69 06:00 PM
An Intake is an intake to me and most other people there are quite a few people here who have the procarparts intake and dont know it, its basically what they sell on ebay most of the time. also as far as altezzas. they are simple. maybe take 20-30 min to put on, if you can undo bolts and put em back on and change your light bulbs you can do it. ;) good luck girl
--Sean B.
"Our time is here, Our time is now, Team 2gnt."
Sponsored by New Edge Racing
http://www.newedgeracing.com
|
4074, RE: intake
Posted by Michael_97RS, Dec-31-69 06:00 PM
Hey Alee, this should be in the performance catagory.
With that said. Are you looking for cold air or short ram?
My Injen has held on nicely with no problems. The big names don't seem to have a problem being held on. I haven't seen the cheaper ones and what kind of bracket they have holding them on.
Hell, I'm unemployed I'll drive up and take a look at yours and see if I can fix it. sure we can rig saomethign up to hold it in place.
"The fastest draw is when the sword never leaves the scabbard,
The strongest way to block, is never to provoke a blow,
And the cleanest cut is the one withheld."
Michael J. Kulaga e-mail: Michael_97RS@2gntDSM.zzn.com
aol IM: MJKulga Website: http://highlander.dsmpower.com/
All Motor Beast in the Making
Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors and Carbon Fiber Pads
To Be Installed: Rear disc brake conversion kit, SS Brake Lines, Rear KVR Cross Drilled Rotors and KVR Carbon Fiber Kevlar Pads
| |