Go back to previous topic |
Forum name | Handling/Suspension |
Topic subject | help getting front lower control arm off |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=6&topic_id=32280 |
32280, help getting front lower control arm off Posted by Hedge, Dec-31-69 06:00 PM
Im replacing my front lower controle arm, the one thats strait. Ive got all the bolts out but i cant get the bolt that is attached to the balljoint to even move. Ive got the nut off already but the bolt its self wont move at all. Does anyone have any tips?
|
32281, RE: help getting front lower control arm off Posted by bullettdsm, Dec-31-69 06:00 PM
Do you have a fork? Hasn't failed me yet. Just be sure to put the ramp down on it so the flat part stays against the knuckle. Sometimes you gotta hammer her good, but it should go.
|
32282, RE: help getting front lower control arm off Posted by freelancefool, Dec-31-69 06:00 PM
Either get the fork, a 2-jaw puller or a pitman arm puller. Any of those should work satisfactorily. The last two will work best if you are trying to save the dust boot.
|
32283, RE: help getting front lower control arm off Posted by dalesmitsu, Dec-31-69 06:00 PM
Originally posted by Hedge Im replacing my front lower controle arm, the one thats strait. Ive got all the bolts out but i cant get the bolt that is attached to the balljoint to even move. Ive got the nut off already but the bolt its self wont move at all. Does anyone have any tips?
buy this tool, this could help. http://www.lowes.com/lowes/lkn?action=productDetail&productId=278279-353-2372-01&lpage=none only 20 bucks for this tool
I haven't diy my lower control arms/balljoints. I'm having a mitsu satan replace them under the recall.
|
32284, RE: help getting front lower control arm off Posted by mcgyvr, Dec-31-69 06:00 PM
I love my Pickle Fork...
|
32285, RE: help getting front lower control arm off Posted by CODE4, Dec-31-69 06:00 PM
Originally posted by dalesmitsuOriginally posted by Hedge Im replacing my front lower controle arm, the one thats strait. Ive got all the bolts out but i cant get the bolt that is attached to the balljoint to even move. Ive got the nut off already but the bolt its self wont move at all. Does anyone have any tips? buy this tool, this could help. http://www.lowes.com/lowes/lkn?action=productDetail&productId=278279-353-2372-01&lpage=none only 20 bucks for this tool I haven't diy my lower control arms/balljoints. I'm having a mitsu satan replace them under the recall.
Uhh what? How is a 1/4" drive cordless going to do anything for him?
He needs a puller or as mentioned a pickle fork to drive in there.
With the CV axle in place you need to use this tool:
|
32287, RE: help getting front lower control arm off Posted by Hedge, Dec-31-69 06:00 PM
I used a balljoing picklefork and got it off, thanks for the help everyone.
|