LAST EDITED ON 25-Jun-01 AT 08:17 PM (PST)

email me if you have any hookups, somewhere close to NC to keep shipping costs low would be even better!

photajenic@aol.com


Appearance mods: Razzi body kit, TC Spoiler front nose, Custom dash, Primax 17x7 10 spoke rims, 35% Mirrored Formula-1 tint, painted calipers, braided hose kit, clear side markers

Suspension mods: KYB AGX Struts, Maxspeed Coilovers, Kuhmo escta 712's 225-45-17, Neuspeed strut tower bar, Pilot Lower Rear Tie bar, RRE lower front Tie bar

Performance mods: ICON performance chip, BPE Underdrive Pulley , MSD 6A Ignition Controller, MSD Blaster 2 Coil, FlowMaster 40 Series Delta Flow Muffler, Brospeed 4" Tip, Iceman Cold Air Intake, powerstop crossdrilled rotors

Stereo mods: clarions 8275 headunit, eclipse point source 6x9's, JBL 15" Sub, PPI 6.5's w/Carbon fiber domes, PPI a404 amp, Pioneer 200w amp

Wish List: Soon......some kind of boost...........

What does it do for ya? I have not heard of that one. Does it piggy back on the stock ECU? Where does it plug in?

DeanoD
1997RS-NeverTurbo
http://ar.dsm.org

It plugs inline with he stock ECU and allows you to advance/retard the timing +/- 20 degrees.

Appearance mods: Razzi body kit, TC Spoiler front nose, Custom dash, Primax 17x7 10 spoke rims, 35% Mirrored Formula-1 tint, painted calipers, braided hose kit, clear side markers

Suspension mods: KYB AGX Struts, Maxspeed Coilovers, Kuhmo escta 712's 225-45-17, Neuspeed strut tower bar, Pilot Lower Rear Tie bar, RRE lower front Tie bar

Performance mods: ICON performance chip, BPE Underdrive Pulley , MSD 6A Ignition Controller, MSD Blaster 2 Coil, FlowMaster 40 Series Delta Flow Muffler, Brospeed 4" Tip, Iceman Cold Air Intake, powerstop crossdrilled rotors

Stereo mods: clarions 8275 headunit, eclipse point source 6x9's, JBL 15" Sub, PPI 6.5's w/Carbon fiber domes, PPI a404 amp, Pioneer 200w amp

Wish List: Soon......some kind of boost...........

Eric, could you give us a website or some other source of information about the ICON chip? I'm sure alot of us would appreciate it.

Todd Scungio
98 RS
15.803 @ 86.48 MPH

www.superchips.com the one i have is for the 2.5L V6 Avenger, they make a 420a version, youmay want to email or call them, The guys over at ASOG.NET got a group buy together and got them for @ $300,

now back to my SWAY BAR request, hehehehe

Appearance mods: Razzi body kit, TC Spoiler front nose, Custom dash, Primax 17x7 10 spoke rims, 35% Mirrored Formula-1 tint, painted calipers, braided hose kit, clear side markers

Suspension mods: KYB AGX Struts, Maxspeed Coilovers, Kuhmo escta 712's 225-45-17, Neuspeed strut tower bar, Pilot Lower Rear Tie bar, RRE lower front Tie bar

Performance mods: ICON performance chip, BPE Underdrive Pulley , MSD 6A Ignition Controller, MSD Blaster 2 Coil, FlowMaster 40 Series Delta Flow Muffler, Brospeed 4" Tip, Iceman Cold Air Intake, powerstop crossdrilled rotors

Stereo mods: clarions 8275 headunit, eclipse point source 6x9's, JBL 15" Sub, PPI 6.5's w/Carbon fiber domes, PPI a404 amp, Pioneer 200w amp

Wish List: Soon......some kind of boost...........

I got a GS-T rear sway bar for free from a guy in the Rochester DSM club who upgraded and didn't want it anymore. Its a pain in the ass to install, and you need to get new rubber bushings for it to fit. (like 3 bucks each at Satan).

The bar bangs against the exhaust piping since the rear contol arms of the 96 GS-T and 99 GS are configured differently. (really F'n annoying). I do notice a sharp difference in performance, however, which is why I kept it on.

Just go to any junk yard and look for a GS-T or TSi. Take a bunch of wrenches with you, and 5 minutes later you will have it.


-Jeff
1999 Mitsubishi Eclipse GS-T'd

http://gs.dsmpower.com