Anyone know of a good place to get this arm. I have gotten one from a local yard but its screwed up on the ball joint. Anyone else have access to one or know where to get one other than satan. Its the lower control arm that is curved. The one I had on there was curved a bit too much after meeting a curb a few months back.

TIA

Chad

i have one from a car with 60k on it...pm sent. otherwise its dealer only.

Terry

yep, unfortunately it is a dealer only part. my suggestion would be to order one from bob kise, or hit up a dodge dealer, they're substantially cheaper than mitsu dealers all day long.


the first solution that comes to mind for any new problem with my car usually involves a can of gas and a match.....:wallbash

You might find Tallahassee Mitsubishi to be cheaper. Those are Mitsu parts, not Dodge parts. Chassis parts for a 2GNT are cheaper from Mitsu, and drivetrain parts are cheaper from Dodge, as a rule.

http://www.worldparts.com/tallmits/

Give them a shot.

Originally posted by Ducking_Fumbass
You might find Tallahassee Mitsubishi to be cheaper. Those are Mitsu parts, not Dodge parts. Chassis parts for a 2GNT are cheaper from Mitsu, and drivetrain parts are cheaper from Dodge, as a rule. http://www.worldparts.com/tallmits/ Give them a shot.

the exact opposite has been my experience, at least here in VA, could be a regional thing though :shrug


the first solution that comes to mind for any new problem with my car usually involves a can of gas and a match.....:wallbash

I have had the best luck going to the company that made the part itself. For engine parts, I have found Dodge to be cheaper, but for suspension/interior parts, I have found Mitsu to be cheaper. I would recommend sourcing both.