does anyone know what the dimensional specs on the front and rear knuckles are? I know I have a bent front and rear knuckles, judging on the distance of the top of the tire to the top of the knuckle, and comparing left to right. Thing is, is that I'm not even sure what that distance should be. If anyone could measure a known good knuckle from the center of the hub to the very top-most portion, I would greatly appreciate it, this way I would know for sure that the other two are good or not. TIA

From the top of my head, I get about 2 fingers (about 2 inches) atleast between the tire and bolt ont he upper control arm. You had to do something big to bend them, alot of times the bearing will go to so a sign to know. On my eclipse the upper control arm was stuck and made it seem like the knuckle was bent.