| Go back to previous topic |
| Forum name | Handling/Suspension |
| Topic subject | ATTN BoostedGS: GSX/AWD Sway Bar Question |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i6&topic_id=24437 |
24437, ATTN BoostedGS: GSX/AWD Sway Bar Question
Posted by Eclipse97, Jun-18-04 06:25 PM
I guess you seem to be the only person on this board who has 'em on without any trouble. The only difference is your exhaust setup. You mentioned you have a 3 inch cat back exhaust. Does the exhaust piping bend in the same manner as stock or is it totally different than stock?
Just want to make sure, cuz you're the only one who haven't had trouble putting it on.
Thanks
|
24443, RE: ATTN BoostedGS: GSX/AWD Sway Bar Question
Posted by BoostedGS, Jun-19-04 06:11 AM
I have the 3" thermal catback. The piping runs in the same location as stock, except it goes under the lower A-arm in the back. The AWD rear sway has extra bends to match their cars, but I still got it to fit fine. It was just a bit of a puzzle feeding the bar from one side to the other. :)
|