| Go back to previous topic | | Forum name | Handling/Suspension | | Topic subject | illumina's/H&R's installed...questions..... | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i6&topic_id=13170 |
13170, illumina's/H&R's installed...questions.....
Posted by BMPDirk, Nov-05-02 09:52 AM
1. When tightening the bolt on op of the strut, how do you know when it's on there tight enough?
2. How do you know what level the strut is on(1-5)? And how do you adjust them properly?
-thanks
|
13171, RE: illumina's/H&R's installed...questions.....
Posted by Clay, Nov-05-02 03:30 PM
adjust the illumina's shock setting by turning the knob with a flat head screwdriver. on the knob u should see two white marks, which will point to a vertical line directly opposit the number setting. not to sound mean but the illumina install instructions would be more helpful. good luck btw
EDIT: don't lose the red cap with the numbers marked on it, its the only way you'll be able to adjust the shock.
|
13172, RE: illumina's/H&R's installed...questions.....
Posted by vegasdsmr, Nov-06-02 05:03 AM
the nut on top of the strut is a self locking nut... just tighten it until it is tight... i think the torque spec for it is on corbin's writeup, off hand, prolly 12lbs of torque...
mine actually loosened up a lil, so i retightened them.... just turn the wrench til its tight, then go an extra 1/2 rotation or so ;-)
good luck,
|
13173, RE: illumina's/H&R's installed...questions.....
Posted by BMPDirk, Nov-06-02 12:54 PM
hey man, thanks....i was concerned about that. Thanks alot!
| |