I am going to install mine real soon and want to cut the trim pieces for the bar to go through. Anyone have any pictures of it like that? Thanks, Rob (GSsport)

on a similar note, i was wondering if anyone had measurements of the eclipse rear upper STB. the length of just the bar, and the length from mount to mount

i plan on making a custom bar for my venge, but from pics the mounts like the same, but im wondering if the length is close enough that it be easier for me to use or modify an eclipse bar

thanks!!!



www.groundfloormotorsports.com

You can see mine on my web site under interior. The Tenzo bar seems to have different mounts than other bars and puts it an inch or two lower. I just cut a square section out so I could put the covers over the brackets.

John
AOL IM: John99RS
john99rs@hotmail.com
http://johnseclipse.homestead.com

I can't wait to get all my parts on.

theres one on my site too. i used a 1/2" bit and holed it out a little bigger to accomodate the bar. it fits so glovelike that any small change and i wouldnat have been able to use it. it rests on ym speaker enclosure and presses down a little on it actually and then the hatch cover closes on top of it barely.
http://www.geocities.com/blue2gnt