a shop(goodyear) tell me I have to get a camber kit(front , rear) in order to do the alignment for Eclipse, and they dont't promise anything. I lowered for about 2.2" and I got the rear camber kit. Is that the truth?

Ken

5zigen rearsection/Cherrybomb glasspack resonator/injen short ram intake/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/Enkei RSF2 17" with Kumho/ Nakayamaprojectors /WW 3 pieces wing/M3 mirror/interior mods

Yes this is the truth, they can adj. toe caster etc.. but its kind of pointless if the camber is off. And anything over 1.5" drop will USUALLY require camber kits

I was having the same problem. My car is lowered 2" and no place in town can do an alignment because my car is too low to drive over the machine. I even have camber correction kits on the front, and I fixed my camber on the rear by adding washers behind the bolts.

Luckily, some of the guys in my car club (Colorado DSM) have the tools to do it yourself.

yes most alignment shops cant do it when your lowered you have to go find one with the special machine for lowered vehicals, it used like gps/satelite or something instead of the laser beam under the car.

Thats how most work is the shoot a laser beam from one tire to the other under the car.

I got around this by holding the black plastic shield up as they aligned it, that is what is blocking the laser, its on the driver side its the black plastic guard thats right below the battery area

they said they can do lowered car and that was the camber issue matter them.

Ken

5zigen rearsection/Cherrybomb glasspack resonator/injen short ram intake/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/Enkei RSF2 17" with Kumho/ Nakayamaprojectors /WW 3 pieces wing/M3 mirror/interior mods

gotta get the kit then

>I was having the same problem. My car is lowered 2" and no
>place in town can do an alignment because my car is too low
>to drive over the machine. I even have camber correction
>kits on the front, and I fixed my camber on the rear by
>adding washers behind the bolts.
>
>Luckily, some of the guys in my car club (Colorado DSM) have
>the tools to do it yourself.

Off topic.

I'm not a fan of red cars, but your's is one of the nicest cars I've seen.. Very clean. I'm envious..

my cars lowered about 1.5 with a prokit so do you think i could get my car aligned at any shop or do i need to find those special shops?

>I'm not a fan of red cars, but your's is one of the nicest
>cars I've seen.. Very clean. I'm envious..

Thanks! It's hard to keep a car in good condition here in Colorado. The city dumps so much sand on the roads in the winter and it really tears up your paint. I just had the front of the car repainted last November, so it's looking pretty clean so far.

BoostedGS,

What kind of rims are those? Thumbs up brotha!

17" Konig Reigns. Thanks again!


"They're 20's.....okay they're 10's but I keep em real clean!" - Next Friday :)