| Go back to previous topic | |
| Forum name | Handling/Suspension |
| Topic subject | Need instructions for GS-T sway bars on RS |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=6&topic_id=1034 |
|
1034, Need instructions for GS-T sway bars on RS Posted by EvuLFleA, Dec-31-69 06:00 PM Is there a page or anything. Can anyone help me because I just bought the front and rear. | |
|
1035, here ya go.... Posted by JasonESi_T, Dec-31-69 06:00 PM It's what I used for mine. REAR only. There isnt any out there for the fronts which will be harder probably. | |
|
1036, RE: here ya go.... Posted by juan, Dec-31-69 06:00 PM
| |
|
1037, RE: here ya go.... Posted by EvuLFleA, Dec-31-69 06:00 PM Hey Jason how long did it take you to do it? | |
|
1038, RE: here ya go.... Posted by JasonESi_T, Dec-31-69 06:00 PM I think it took me two hours tops. IT really wasn't too bad either. I think it was the first REAL mod I ever did as well. Definitely the first suspension mod ever. Just get a breaker bar as that'll make it easier for any tough bolts. You know how it goes with suspension stuff. It's all about removing bolts. | |
|
1039, did you get the correct bushings for the front? Posted by DeanoD, Dec-31-69 06:00 PM GS-T uses the same mounting brackets and endlinks for the front sway. It has to have (front)19mm bushings(rubber or poly) instead of the 16mm that are in there already on your RS. If you did not buy the new bushings for the front sway bar, do not install it until you have them. I think I also removed my front right wheel and lower brace below the swaybar. It kind of dropped out one side and pulled it through the wheel well...from what I can remember. | |
|
1040, RE: Need instructions for GS-T sway bars on RS Posted by gzrs99, Dec-31-69 06:00 PM Check the mods on 2gnt.com. Instructions are straight forward. job can be done in 1-1/2 -- 21/2 hours. For me, I found it easier to use a 17mm 6pt socket or 6pt box wrench. I tried using a 12 point socket/wrench I ended up stripping the bolt heads. It's easier, if you try removing/loosing the nuts on the LCAS first. Remember, SAFETY FIRST USE THEM jack stands if available. | |
