Looking to see if anyone with close to the same mods as me will share their msq. I just finished installing my ms2 and a going to be running fuel only to get the hang of things. Here's a full mods list:

Motor:
Port matched head
Crower valve springs and titanium retainers
SBI rockers and lifters
Stock valves
Crower stage 2 n/a cams
Unorthodox adjustable cam gears
ARP head studs
.020 over JE 8.8:1 Pistons & Rings
Eagle H Beam rods
ACL main and rods bearings
Unorthodox UDP

Drivetrain:
Spec custom stage 3 clutch
3.55 trans with quaife LSD
Stainless braided clutch line
B&M Short throw shifter

Intake/fuel:
Custom made AMM turbo intake manifold
60mm throttle body
750cc High z injectors
Aeromotive 1:1 RR FPR
Walbro 255
Fuel pump rewire

Exhaust:
Hahn 3" v-band eliminator dp
3" Thermal exhaust system

Turbo:
Hahn Racecraft S16g turbo w/internal wga
Hahn FMIC and Pipes
Synapse Synchronic BOV
Hahn turbo log manifold
Stainless Oil feed and drain

Engine management/other:
Symtech MS2
Zeitronix ZT-2 With ZR-2 gauges, EGT probe, Boost sensor
Screamin demon coil

Suspension:
K-Sport coilovers
Front and rear strut tower bars
Fluidyne radiator
Spal slim fans
Prothane motor mounts

Im not to far off, stock cams and intake, 650cc injectors. Holset turbo on 24psi with meth. It would be an ok starting point.

That's kind of close to mine. I'll see if I can get my file off my shitty MS laptop today or tomorrow. Been real busy trying to get this damn thing ready for the SO!