Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectRE: MS2 - Stalling After Start (No Idle)
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5700&mesg_id=5807
5807, RE: MS2 - Stalling After Start (No Idle)
Posted by Tired2, Dec-31-69 06:00 PM
Okay, I did some reading. I think mine just runs backwards, I'll probably need to switch a coil around on the IAC to make it run the other way.

I think I'm fine for open loop still, and probably would be good for closed loop, but I imagine I'd have to invert my gains and such, which might not be worth it since I should only have to swap one set of wires.

I'll be waiting though, until I can pull the TB off again though to really map out the steps/location.

OP ----

Just be sure you verify yours, if yours is wired differently than mine is (very possible), you could be adjusting the wrong way.

This may cause problems with homing it as well.
I generated this page in 0.0081138610839844 seconds, executing 6 queries.