| Go back to previous topic |
| Forum name | Engine Management Systems & Controllers |
| Topic subject | RE: MS2 - Stalling After Start (No Idle) |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5700&mesg_id=5803 |
5803, RE: MS2 - Stalling After Start (No Idle)
Posted by Gruff511, Dec-31-69 06:00 PM
Yeah i remember seeing over on msextra some of ms2 codes are actually programmed so the IAC steps are higher when closed..when the later firmwares are opposite where fully closed is 0 steps.
But either way the OP idle is high revving because its getting too much air, probably since he has closed loop off and other parameters are working his idle. While if running closed loop the ecu will adjust steps to steady idle
|