5753, RE: MS2 - Stalling After Start (No Idle) Posted by RfOeCnKdOeNr, Dec-31-69 06:00 PM
Originally posted by Tired2 Oh, and I noticed it has calibration options on it for the analog output. Make sure that the rotary switch in the back is on setting P0 or P1, otherwise you'll be on a different voltage scale that the ECU does not expect. 0-5v is the default (P0/P1)
Thanks... and thanks for the clarification above. It never crossed my mind until you posted the PDF for the UEGO. I installed the wideband over 4 years ago so I completely forget about the two pin outs! Well, let's just hope the MS didn't fry.
Thanks again and I will keep you all posted! I hope this discussion helps someone along the way as well.
|