Go back to previous topic |
Forum name | Engine Management Systems & Controllers |
Topic subject | RE: MS2 - Stalling After Start (No Idle) |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5700&mesg_id=5705 |
5705, RE: MS2 - Stalling After Start (No Idle) Posted by SilvrEclips, Dec-31-69 06:00 PM
Yes the throttle should be close to 0% and 100% on the min. This will effect things like over run and closed loop idle if you choose to use those features.
I would leave the required fuel where it set it to and adjust your VE table. If you are running a base map I would scale the whole map when you make changes to try and richen it up. Then once you get the car idling you can see where you need to make changes to.
That sensor is your map sensor, you need to set it to whatever sensor is on the board.
|