Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectMS2 - Stalling After Start (No Idle)
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5700&mesg_id=5700
5700, MS2 - Stalling After Start (No Idle)
Posted by RfOeCnKdOeNr, Dec-31-69 06:00 PM
Hey Guys,

So I finally got Megasquirt to start my car! Thanks to a distress call to Marc (Bullett) it turns out the car was not starting because the wires to the coil pack were reveresed.

Well, I finally got it started using Symtech's 420A base map. I am using MS2/Extra v3.2.4.

The only thing I changed were the required fuel and injector settings.

The car turns over now and runs for about 2 or 3 seconds before stalling. If I hit the throttle a bit here and there I could keep it alive for a little long but not much more.

Here are my log and msq files.... (I might have throttled during the log).


https://docs.google.com/file/d/0B22tb0XxveQ8UlBOY1dkT3FNbGM/edit?usp=sharing
https://docs.google.com/file/d/0B22tb0XxveQ8VDNpU1huR2FSM0E/edit?usp=sharing

Any ideas?!

I generated this page in 0.0085430145263672 seconds, executing 6 queries.