Originally posted by Gruff511
You should use the MSQ basemap on there. Which board and firmware are you running? by using someone else's msq. they may have features activated that works for them but might not work for you. so for instance before you try to start it for the first time just make sure everything is turned off. And with large injectors like those, you'll set the 'Req. Fuel' in your fuel settings then scale down your VE table so when you first start your not dumping loads of fuel into the cylinders. And keep in mind when you first start your afr's will be rich if you have ASE on and WUE on too high.

Awesome thanks!

For the required fuel does anyone know what the displacement value would be for a 2.0 bored over .020... I searched here and only found some good posts for a 2.4L conversion.?