| Go back to previous topic |
| Forum name | Engine Management Systems & Controllers |
| Topic subject | Who is running a AEM wideband with megasquirt? |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5497 |
5497, Who is running a AEM wideband with megasquirt?
Posted by rst_eclipse, Dec-31-69 06:00 PM
Im just trying to find out who all is running the AEM wideband with megasquirt because I have a AEM wideband and I plan on using megasquirt but I don't want to loss my wideband.
|
5498, RE: Who is running a AEM wideband with megasquirt?
Posted by Wes Tank, Dec-31-69 06:00 PM
Me. Why would you have to lose it?
|
5499, RE: Who is running a AEM wideband with megasquirt?
Posted by CODE4, Dec-31-69 06:00 PM
Why are you worried about losing it? Are you asking if they are compatible? Have you taken the time to read the MSextra manual? This is not new information by any means.
|
5500, RE: Who is running a AEM wideband with megasquirt?
Posted by Dstach, Dec-31-69 06:00 PM
Yea you use the white wire. It's the 0-5v wire. AEM gives you a chart as well. If you can not find it I can post it.
|
5501, RE: Who is running a AEM wideband with megasquirt?
Posted by rst_eclipse, Dec-31-69 06:00 PM
I have not purchased the megasquirt system yet, but all I see on the site is inovative and I was just wanting to know. Thanks for the input!
|
5502, RE: Who is running a AEM wideband with megasquirt?
Posted by SilvrEclips, Dec-31-69 06:00 PM
I run this combo as well. The MS reading is within 0.2 AFR of the AEM gauge.
|
5503, RE: Who is running a AEM wideband with megasquirt?
Posted by Dstach, Dec-31-69 06:00 PM
Did you plug in the right variables? It should be exact.
|
5508, RE: Who is running a AEM wideband with megasquirt?
Posted by 740 turbo brick, Dec-31-69 06:00 PM
Mine is always off by .1 AFR. If my laptop reads 15.0, my gauge reads 15.1. I used the calibration I saw for my UEGO part number and its always been like that. I love it though. I wouldnt use another Wideband over AEMs.
|
5509, RE: Who is running a AEM wideband with megasquirt?
Posted by Gruff511, Dec-31-69 06:00 PM
Ive been using my innovate mtxl and using the calibration thats recommended from Innovate they say its 0v=7.34-5v=22.39 But when connected to MS the readout is off by 0.3-0.4!!
|