Just finished building my MS2 ECU. Did the board mods for the crank sensor, internal ignitors, and the IAC control. The board loaded the firmware just fine, however who I go to load my base map I get a bunch of errors and most of the gauges in TS are X'ed out. I tried loading a code from Symtech and same thing happened.

Right now Im using the Stim v2.2 and MS reads tps, IAT, Water Temp, Map.

Heres a screen short of TS.

http://i189.photobucket.com/albums/z173/SilvrEclipse/Untitled-1.jpg?t=1330805825

Post firmware version you loaded.

Attach MSQ.

Post screenshot of the errors it gives you.

I am running MS2/Extra Serial 321.



Im not sure how to post the tune on here.

Seems to be fixed now. Apparently TS had to be set up to the MS2 outputs for the gauges.