Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectRE: Dash Tach Erratic Behavior MS2 V3 Standalone
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5432&mesg_id=5438
5438, RE: Dash Tach Erratic Behavior MS2 V3 Standalone
Posted by teklein, Dec-31-69 06:00 PM
Originally posted by VelocitaPaola
Originally posted by teklein Anymore ideas on this? Triple checked everything I have already triple checked - cannot find anything wrong.
Did you check with whoever built your ECU? If you're sure the settings are correct, and the wiring is sound, then there must be a hardware problem.


Dave built it. Its not the builder, passed on thr JimStim.

I am going to swap a different cluster in. Maybe the tach went bad while the harness was apart. Ive seen weirder things.
I generated this page in 0.0076549053192139 seconds, executing 6 queries.