Go back to previous topic |
Forum name | Engine Management Systems & Controllers |
Topic subject | RE: Ms2 V3.0 420aa decoding |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5424&mesg_id=5430 |
5430, RE: Ms2 V3.0 420aa decoding Posted by SymTech Labs, Dec-31-69 06:00 PM
Originally posted by Dstach small clarification. SO I can put the resistor inline with the signal wire going to MS. and when building the board just skip where is says for the vr/ hall sensor?
No, you need to build the Hall/opto circuit and configure it using the 330 ohm - 1.5k ohm resistor as shown in the schematic you posted. We use the standard 390 ohm resistor (R12) in our ECU's, but connect a 1k ohm resistor in series between the R12 and 5V/Vcc.
|