Go back to previous topic | Forum name | Engine Management Systems & Controllers | Topic subject | RE: INJECTORS NOT SQUIRTING, standalone ms2 | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5363&mesg_id=5370 |
5370, RE: INJECTORS NOT SQUIRTING, standalone ms2 Posted by CODE4, Dec-31-69 06:00 PM
Originally posted by reborn750 i changed the priming pulse values a little to see what result i gained. I noticed my pwm values are for high impedance injectors, but i looked and the pl4-1200 injectors i have are peak and hold injectors which mean low impedance correct? Could i have burned up my injectors? i tossed in a factory injector earlier though and it did not open either. Any easy way to post a msq file.
Upload here http://www.2gnt.com/upload.php
Have you read the MSExtra manual on setting up injectors? What Megasquirt board/processor do you have?
What are your PWM settings? Do you have the correct dead time/injector latency setup?
| |