Go back to previous topic |
Forum name | Engine Management Systems & Controllers |
Topic subject | RE: Wide bands: what wide bands do you use? |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=5331&mesg_id=5340 |
5340, RE: Wide bands: what wide bands do you use? Posted by 96TurboGS, Dec-31-69 06:00 PM
My AEM UEGO will not match up right under any sensor settings even if it’s grounded at the same spot. Many people have had this problem I have and there isn’t many solutions with the UEGO other then using the custom wideband table in TS. I have done the calibration table and have gotten it to read exact numbers. My numbers were off by .2. Jean’s explanation on msextra is a good start, I too would prefer a digital signal over anolog anyday. Had mine for a while now without any problems.
|