Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjecttuning idle...msnsE seqential
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=4969&mesg_id=4969
4969, tuning idle...msnsE seqential
Posted by streetlightning, Dec-31-69 06:00 PM
the open time is set to .65ms. heres a shot with wue and ase off, its steady for a bit then gets a little lumpy. I can see the rpm gets a little lumpy, is this noise?
it seems the rpm jumps and dips but for the most part everything else stays steady...

Can i force an IAC step number while the engines running? like if its at 10 steps, and i want to add air, can i add steps and burn that table while engines running?

any ideas on how to smooth it out?
I generated this page in 0.011165857315063 seconds, executing 6 queries.