| Go back to previous topic | | Forum name | Engine Management Systems & Controllers | | Topic subject | Low Z injectors on MSii | | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=4930 |
4930, Low Z injectors on MSii
Posted by streetlightning, Dec-31-69 06:00 PM
oK, i have been reading and asking?s, now i have one regarding my injector choice...
I have Preciion 1000cc Ball and seat low Z injectors. I thought the ms2 had enunf resultion to run them>? now people are saying i need a peak and hold board to run them? i see some have used peak and hold on MS1, but was that b/c of the lack of resolution? or do i need the peak and hold board? or can i do something else? sigh.. thanks in advance...
PS. symtech, what are your hr.. no one ever seems to pick up and email seems slow.. i need to get this resoved asap to know if i need to send it back for more stuff ect..
|
4931, RE: Low Z injectors on MSii
Posted by VelocitaPaola, Dec-31-69 06:00 PM
Originally posted by streetlightning
oK, i have been reading and asking?s, now i have one regarding my injector choice... I have Preciion 1000cc Ball and seat low Z injectors. I thought the ms2 had enunf resultion to run them>?
It does.
Originally posted by streetlightningnow people are saying i need a peak and hold board to run them?
It's not absolutely necessary; the JBPerf P&H Board or the SymTech Labs PH Driver are optional upgraded fuel injector drivers. The standard fuel injector drivers work well too, but you have to configure the parameters for low impedance injectors in MegaTune or TunerStudio MS.
Originally posted by streetlightningi see some have used peak and hold on MS1, but was that b/c of the lack of resolution?
Many Megasquirt users use the P&H Board or PH Driver for a variety of reasons. The issue with MS-I and low impedance fuel injectors is complex, but it suffices to say that it does not affect your system.
| |