One thing that I just thought of today. I have 2 injectors running of each wire coming from MS. Both of those wires are soldered between the connections on the plug going into the unit. Would this throw off the resistence that MS is expecting since I have it set to low-z settings? Im thinking about running a resistor pack and upgrading to the high resolution version and testing that out but Im trying to get this working first since the HR version cant control low-z injectors.

So MS has 4 injector outputs and I have 4 injectors but am only using 2 wires to transmit the signal. this is how the diagram showed to hook them up but Im wondering if this is going to impact how I install the resistor pack.