Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectRE: Few electrical connection questions for the MS..
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=412&mesg_id=425
425, RE: Few electrical connection questions for the MS..
Posted by ner947, Dec-31-69 06:00 PM
Originally posted by XtremeRS
...For the TPS signal, we just tap right off of the brown/red wire right? No resistors or anything special here?


Yep. Just tap the center pin on the TPS. You have to calibrate it in MegaTune though.

Originally posted by XtremeRS
...The crank position sensor- just tap off of the blue/white wire also??


I think so. Make sure your board has the crank sensor hardware modification and check the option in MegaTune. I'll be snowed in tomorrow so I'll probably do the mod to the board so it will accept the factory crank sensor.

Originally posted by XtremeRS
I will also be using the Mitsu power transistor ignition module for spark, so does anyone have the pin-outs or wiring diagrams of how to wire this thing up?


http://www.stealth316.com/2-pwrtransunit.htm
I generated this page in 0.0075170993804932 seconds, executing 6 queries.