| Go back to previous topic |
| Forum name | Engine Management Systems & Controllers |
| Topic subject | RE: MS v2.2 circuit question |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=3854&mesg_id=3864 |
3864, RE: MS v2.2 circuit question
Posted by SilvrEclips, Dec-31-69 06:00 PM
Can someone just post a nice big pic of what the v2.2 board is suppose to look like so I can change mine around to match it. Instead of figuring out whats going on I planned on just removing all of the alterations and starting from there.
Also I started building my wiring harness and noticed that they gave me a lot of IAC wires but not a crank position sensor wire. The pic of the 2.2 board wiring doesn't show a CPS but the 3.0 wiring does. Do I just hook the wire to the same pin?
|