Just as it sounds. Got most bolt ons, 75 shot of Nitrous (but I am not too concerned about that at this point).

Running MSnS Extra Code 29t on a 2.2 board.

code4@zero-signal.org

Thanks.

OK, I know this is only 6 months late, but it could help someone. The 20 KPA bins are still a WIP, they should interpolate within the surrounding cells. I have had this map to 6800 RPM with a steady idle and a flat 13.1 A/F at WOT from 4000-6800 RPM with a LC-1. This map is for a street port, .020 milled head, port matched intake, stock injectors, ~14 req fuel, alternate, 2 squirts.
Try it at your own risk. I take no responsability if you blow your motor. Good luck!
http://www.putfile.com/pic.php?img=5139893>

Mark posted his N/A base map here... remember that he's using 4G63 ignitors and a built engine though...

http://putstuff.putfile.com/64992/5830956

-http://www.symtechlabs.com/-

Thanks for the replies, even though late. The Eclipse is currently sitting under a cover in the backs woods in VA while I am out on deployment. I got a base map to work with and have done alright. Thanks again though.