Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectRE: Running MSnS v3 Board as FULL Standalone (No Spikes)!
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=2549&mesg_id=3386
3386, RE: Running MSnS v3 Board as FULL Standalone (No Spikes)!
Posted by WickedESi, Dec-31-69 06:00 PM
You've installed the active flyback circuit on the v3 board?

I don't have this, so my PWM % must be set to 75% w/ my low impedance injectors.

Go to the manual:
http://www.megamanual.com/v22manual/mtune.htm

and do a press ctrl+f and find "If you have low impedance injectors (less than 4 Ohms), set the:"

Make sure you have the active flyback circuit installed if you are running a 30% PWM.

Also, what fuel pressure are you running? try lowering it?
I generated this page in 0.010015964508057 seconds, executing 6 queries.