Hate to do this... but read the bottom of the first post:
Originally posted by WickedESi
Tuning the MS Pots
- To tune the crossover point (R52) disconnect your fuse on your ASD supply wire. Crank the car, turn the pot 1 revolution clockwise till the crank RPM dissappears, then note how many it was in that direction. Then do the same in the other direction, then put it in the middle.
- Leave the hysteresis pot at zero to 1/4 turn for the most stable signal. If you happen to get any noise crank this clockwise until it vanishes (too much and your signal will dissappear completely).
;)
Glad you're at the fun part now!