I've been driving around with this beta test code for a bit now, and it's running flawlessly..This Hi res code basically give a LOT more fuel injector resolution in the injector pulse width. MT displays PW as x.xxx now :) The car has never idled as good as it has since using this code. Drives around excellent. Enabled the autotune feature in MT, and o2 corrections are perfect all around now. Thanks to Shawn(boostjunkie) for gettting this code in gear! Note: there are still a few "extra" code features that are not working yet,like prime pulse when the key is turned on, but all basic features and functions are there.. The code is derived from the 029q2 firmware, works with the MT release version 2.25. This code will greatly help the large injector people..i'm only using 440's for now, but even still it makes a good difference, as the wideband shows more consistant A/F with less jitter. Give it a try if you want..

http://www.wowway.com/~kgrider/saab/hr_08d.zip

Remember to do the .ini file thing, and use the MT configurator to name a new car project, then configure your new project. The download firmware bat file will upload the code(only if you have a current "Extra" series of code already in your processor). Drop the .ini file into your project "mtcfg" folder. NOTE: This code will run slightly RICHER. Plan on taking out roughly 2-4% from your VE table, mostly in the 100 kpa bins and below. Boost was only off by maybe 1-2% at most.