Well, my sig below is my setup and I really want to get to about 300whp. I have a just about everything I need to do that except for axles, fuel and timing. Am I going to need an SFMU with the emanage? Or will having the aeromotive 1:1 require too much tuning fot the emanage? I want to run 10lbs of boost and get used to everything, then bump it up and get it tuned for around 300, and then probably more. Any thoughts? I am new to tuning, I have a Zeitronix WBO2 with EGT gauge also for tuning. Help me out guys.
~Jeffo



Top end: Ported and polished head, REV stainless Valves, Crower stage 2 cams, Crower valve springs and titanium retainers, SBI rockers and lashers, Fidanza Cam gears, ARP Headstuds.
Bottom end: JE 8.8:1 pistons, Eagle H-beam rods, Balance rotating assembly, Clevitte Rod and Main bearings, Melling oil pump, Crank scraper, carter water pump.
Ignition: MSD Coil, MSD wires, NGK iridium spark plugs.
Bolt ons: MP 60mm throttle body, ported and polished intake manifold gasket matched, Magnaflow catback, high flow cat, Unorthodox UDP, Ground wire kit.
Suspension: Eibach Ground control coilovers, KYB AGX gas adjustable struts, Strut tower bars.
Drivetrain: SPEC stage 4 clutch
Body/Interior: VIS Evo carbon fiber hood, stock red body, stock black 16" rims. Ractive carbon shift boot and ebrake boot, Ractive carbon blue gauges (boost, oil press., volts, and cluster, blue underseat lights.
Installing at the moment: Garrett t3/t04e stage 2 water cooled turbo, RC 440cc injectors, Vortech SFMU, HKS SSQV BOV, Star FMIC and piping, Star manifold, 3" Downpipe, Tial 38mm WG, Walbro 255 fuel pump, Missing link.