Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectJoining the MegaSquirt Team!
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i54&topic_id=1272
1272, Joining the MegaSquirt Team!
Posted by gilee_8, Sep-07-05 09:43 AM
Sup guys.
I guess it's time.
My brand new engine is up to 2000+ miles, and ready for heavy boost.
I ordered the WBO2 sensor with MS-II on v3.0 board.
They should arrive by the end of this week (busy weekend haahaa)

Now I have to get some other parts.
for my current setup (read below at the banner), I have to change my SFMU to a 1:1 fuel regulator, and change my injectors (since if I run MS, I want 15PSI to 20PSI running)

So please let me know what I should get:
1) Aeromotive 1:1 fuel regulator
2) 600cc injectors (is it good to 20PSI with only 80% duty cycle and with smooth idling?)

That should be it for me am I correct? I really want to know if I am missing anything?? (I have a laptop already as well)

I do have 2 concerns before I can order the FPR and the injectors.
1) for my current SFMU, I got all the AN fitting and so on, will they FIT directly to the Aeromotive 1:1 FPR? or what do you recommend?
2) What injectors do I have to get to work directly for my setup? what brand and where is the cheapest? is 600cc good for 20PSI and not over doing it?

Thanks guys.
I cannot wait to start tunning my car (the RIGHT WAY)
Gil
1273, RE: Joining the MegaSquirt Team!
Posted by DR1665, Sep-07-05 03:59 PM
WAY TO GO GILEE! :thumbsup
1274, RE: Joining the MegaSquirt Team!
Posted by gilee_8, Sep-07-05 04:34 PM
Getting there.. just cannot wait to get it all set! (prolly by next summer)

So anyone can give me some insight on the above questions?
Thanks!
Gil
1275, RE: Joining the MegaSquirt Team!
Posted by micyek, Sep-08-05 01:37 AM
If I remember right both the Aeromotive FPR and the SFMU use AN-6 fittings...so with a little luck you should be ok. But if your like me, you never know what you're gonna need until you tear into it, especially when it comes to fuel fittings.

good luck man...
1276, RE: Joining the MegaSquirt Team!
Posted by Avenger, Sep-08-05 04:45 AM
Why'd you order the MS2?
1277, RE: Joining the MegaSquirt Team!
Posted by gilee_8, Sep-08-05 05:18 AM
well, coz when I was in College, one of my Electrical Engineering class requires to take a Microproccesor Design class. and it is using that CPU. So I coded in microprocessor for 2 semester, and so I think I am play around with it more.

And it has alot more potential.
I konw it's not mature yet, but I will start off with Fuel first, then move on to other things, so it's ok for now.
So what injectors should I get? and where?
any help there? thanks.