Originally posted by RxR_Eclipse
nice, I have an xtra plentium that I will be doing the same too. I already paid MrSlick for my MS. I have collected up all the sensors/ignition parts and the new injectors. More or less just waiting on the MS unit. Good job on that. These are the fuel injectors I got. Although when I tested the ohm load I came up with the same as my stockers. Part Number 3105 Static Flow Rate (GAS): 86 lb/hr @ 43.5PSI (300kPa) = 903cc/min, 10.88g/s Static Flow Rate (Test Solvent): 83 lb/hr @ 43.5PSI (300kPa) Coil Resistance: 2.35 Ohms / Low Impedance / Low-Z (ECM driver modifications required)

I'm in a similar boat, I have paid Mr. Slick (28th of january) and am awaiting my unit. I have not purchased any sensors or anything, and will be running on my (mostly) stock car for testing before I install a turbo (which I am ordering today). Do you know of any lst of other hardware we need to run fuel + ignition, or a link to another post that mentions them? Mr. Slick said he was backordered a bit when I ordered, hopefully he's caught up soon :P.