| Go back to previous topic | |
| Forum name | Engine Management Systems & Controllers |
| Topic subject | RE: Can Anyone send me their ignition table for MS? |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=2442&mesg_id=2443 |
|
2443, RE: Can Anyone send me their ignition table for MS? Posted by Corbin, Dec-31-69 06:00 PM I have the exact same problem. I am using two internal VB921 transistors to drive the stock coil (I think you are too). No matter what I do, I can not get the car to run right with any spark table. It will idle smoothly and I can get up to about 2500 RPM. After that, it just breaks apart. I have a connector that allows me to switch in between MS spark and stock ECU spark. I switch back to stock and the car runs perfectly. Today, I am going to get one of those 4G63 power transistors and see if that works. I'll post if I get it figured out. | |
