Go back to previous topic
Forum nameEngine Management Systems & Controllers
Topic subjectRE: Greddy Emanage ignition timing control
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=1633&mesg_id=1634
1634, RE: Greddy Emanage ignition timing control
Posted by powellds, Dec-31-69 06:00 PM
Also, if I'm using the Emanage, will the walbro 255 and aeromotive 1:1 FPR work? I have all ss lines as well. By the way, sorry for posting in the wrong forum. TIA
~Jeffo



Top end: Ported and polished head, REV stainless Valves, Crower stage 2 cams, Crower valve springs and titanium retainers, SBI rockers and lashers, Fidanza Cam gears, ARP Headstuds.
Bottom end: JE 8.8:1 pistons, Eagle H-beam rods, Balance rotating assembly, Clevitte Rod and Main bearings, Melling oil pump, Crank scraper, carter water pump.
Ignition: MSD Coil, MSD wires, NGK iridium spark plugs.
Bolt ons: MP 60mm throttle body, ported and polished intake manifold gasket matched, Magnaflow catback, high flow cat, Unorthodox UDP, Ground wire kit.
Suspension: Eibach Ground control coilovers, KYB AGX gas adjustable struts, Strut tower bars.
Drivetrain: SPEC stage 4 clutch
Body/Interior: VIS Evo carbon fiber hood, stock red body, stock black 16" rims. Ractive carbon shift boot and ebrake boot, Ractive carbon blue gauges (boost, oil press., volts, and cluster, blue underseat lights.
Installing at the moment: Garrett t3/t04e stage 2 water cooled turbo, RC 440cc injectors, Vortech SFMU, HKS SSQV BOV, Star FMIC and piping, Star manifold, 3" Downpipe, Tial 38mm WG, Walbro 255 fuel pump, Missing link.
I generated this page in 0.015972852706909 seconds, executing 6 queries.