I'm getting my timming belt and water pump changed tomorrow, what pullies should I get replaced?? cuz some of them are squeaking.
thanks.

If you are getting squeaking check the belts if they are cracked replace them if not just tension them properly when you reinstall them and you will be fine

"The fastest draw is when the sword never leaves the scabbard,
The strongest way to block, is never to provoke a blow,
And the cleanest cut is the one withheld."

Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

All Motor Beast in the Making

Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors and Carbon Fiber Pads

To Be Installed: Ported/Polished Intake Manifold, Rear disc brake conversion kit, SS Brake Lines, Rear KVR Cross Drilled Rotors and KVR Carbon Fiber Kevlar Pads

Strictly by nature of design, our tensioner pulleys suck. They seem to ride the outside of the pulley, which puts severe stress on the bearings. Mine was squeaking until I replaced the tensioner. $80 from Satan, though...
-=B-=

You want to replace the tensioner pulley, and there is an identical pulley near it, the idler pulley. I replaced both of these when i did my belt.