Off the top of there head...I can't find the 2 bolts that mount the slave cylinder against the front/bottom part of the bellhousing. If anyone knows the size of that bolt it would be greatly appreciated.

I got the motor swapped over today. Tomorrow will be some more work and then finishing the job.



http://www.dsmregistry.com/detail.php?carid=1030

8's or 10's... Short of pulling miine I couldn't tell you length but I think that they are no longer than maybe .750-1" long... I don't have a service man for that year but I do have the 95 and 97... Only says it should be 18nm or 13ft lbs. Hope this helps some!

they are 10mm but i am not sure of the pitch and they are longer that 1" try 2" or 2.5"

Terry

Originally posted by Star Turbo Talon
they are 10mm but i am not sure of the pitch and they are longer that 1" try 2" or 2.5" Terry

Thanks Terry! I knew it was 8 or 10 I just couldn't remember. And the length? I suck at guessing! I haven't had mine out in a few years. Old-timers is setting in ya know! :)

Thanks for the help guys. I've got a bunch of spare bolts around, so I may be able to find something that fits.


http://www.dsmregistry.com/detail.php?carid=1030

10mm x 1.5 methinks