Poll question: Which Spark Plug Wire?

Poll result (8 votes) Crane Firewire 8.5mm (2 votes) Vote Magnecore 8.5mm (1 votes) Vote MSD 8.5mm (3 votes) Vote Magnecore 10mm (2 votes) Vote (0 votes) Vote (0 votes) Vote

Originally posted by taloniized

No contest. A poll is not going to tell you, imperical data will. Crane wires have the lowest resistance per foot in resistance. 4 ohms per foot. I use them on my personal vehicles.

Originally posted by AFX_Manufacturing
imperical data

dictionary.reference.com/search?q=empirical%20, Chief. ;) :thumbsup


Magnecore 10mm - 2.2kOhm/ft. (That's 2,200Ohms.)

From the CraneCams website
8.5mm wire www.cranecams.com/?show=browseParts&lvl=3&prt=72&PHPSESSID=9c653e2aaac5d00bd5858388ed33a500&showAll=yes, double-silicone, reactive-core design reduces RFI (Radio Frequency Interference) that can disrupt on-board computer and audio equipment function and performance. Ready to install custom sets and universal cut-to-fit sets with or without heat sleeve.

A bit more than four, but way less than 2.2kOhm/ft.

Just thought I would share. :shrug

That is the old Crane wire. If you notice they have a new prefix on the part number indicating the new wire. 250 was the orginal prefix, then new wire is 255- prefix

Wow, those are the two I was debating on too.

Dude I run Crane Wires and a Scream Demon coil on my personal car, and my race cars. I also have access to everything through the store if I want. I choose Crane wires and the Screamin Demon coil packs.

Currently I have the MSD coil pack and MSD wires. I just want to replace the wires for the heck of it.

Nothing wrong with the stock wires..

really.. HV could care less about the low voltage ohm readings..

get an HV coil (that'd be high voltage) and that's all ya need. sure gary wants to sell wires.. and i got no problem with that..

but if you dig around.. and look real hard.. the stock wires were fine for PACWEST.. and.. personally.. i think they know which way up is.

Originally posted by WheatKing
Nothing wrong with the stock wires.. really.. HV could care less about the low voltage ohm readings.. get an HV coil (that'd be high voltage) and that's all ya need. sure gary wants to sell wires.. and i got no problem with that.. but if you dig around.. and look real hard.. the stock wires were fine for PACWEST.. and.. personally.. i think they know which way up is.

I use stock wires w/ my MS setup and they have been fine at 25 psi thus far.

I'd replace the coil first, since the MSD has the same secondary output as stock coil. The Screamin Demon is actually an upgrade over stock.

Originally posted by AFX_Manufacturing
I'd replace the coil first

I would if they had one for 95's.

I have a 95 and I'm running one of demz screamin demon coil packs. Of course I modified my harness also O_o Oh I'm running MSD wires also, they seem to be fine.

Paul, quit trying to be cool and just get some AC/Delco wires! :)

Originally posted by FlyinEsi
Paul, quit trying to be cool and just get some AC/Delco wires! :)

Don't degrade the all mighty talon!:-)

Originally posted by taloniized

Originally posted by AFX_Manufacturing I'd replace the coil first

I would if they had one for 95's.

i've used one on a 95.. just gotta solder the 96+ connector on and away you go.