| Go back to previous topic | | Forum name | Performance/Engine | | Topic subject | quick help guys... arp head studs | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=91625 |
91625, quick help guys... arp head studs
Posted by gilee_8, Jul-18-05 03:45 PM
Sup guys.
I searched already. some said 65ftlb, some said 70 or 80.
but then dino/darkone said 90-100ftlb.
But then others said more ftlb is required for more boost level.
If I plan to run 10-15PSI. what should I set it to?
coz some said 80 is fine, and others said 90-100...
The questions are:
1) What torque spec do I use on the bolts?
2) for stock, outer bolts are less in torque spec, do I do the same for ARP studs?
3) for all the torque specs you guys mentioned before, do I still need to do the 1/4 turns?
I am working on my engine as we speak!
pleaes give me help asap!
Thanks all.
Gil
|
91634, RE: quick help guys... arp head studs
Posted by gilee_8, Jul-18-05 06:34 PM
I guess I have to wait till tomorrow morning to finish torquing the head bolts in.
Can someone give me some input here!
Thanks man.
|
91641, RE: quick help guys... arp head studs
Posted by DarkOne, Jul-19-05 05:37 AM
I always torque them to 90ft/lbs, minimum. Anything less is a waste of time and a good stud, in my opinion.
|
91645, RE: quick help guys... arp head studs
Posted by DR1665, Jul-19-05 07:12 AM
Originally posted by DarkOne
I always torque them to 90ft/lbs, minimum. Anything less is a waste of time and a good stud, in my opinion.
Gil makes a post and gets the information I was looking for myself. Amazing...
Thank you.
| |