best time so far 14.3 @ 101.1mph(no traction)
www.cnnmotorsports.com

holy needs resizing. looks good.

Hey, how did you get it to a 2.5? I had thought about getting the 2.2 stroker kit and gettin it bored.

Are those Aluminum rods I see?

Here are the specs.
JE 2.4 turbo pistons for use wiht 6.145 length rod, 3.48805 bore 8.25:1
Billet Aluminum 2.4 connecting rods. 6.145 length
Everything has been balanced and blueprinted.
srt4 oil pump
srt4 oil pan
It also has a 10k redline which is cool too.

best time so far 14.3 @ 101.1mph(no traction)
www.cnnmotorsports.com

Looks good extreme! Where did you get the block,pistons and rods?

I got my block from the junkyard,I had forwardmotioninc.com do all of my machine work/assembly. I was gona do it yself but I have never built an aluminum rod motor so I had them do it. They are a great shop and know their chrysler motors.

best time so far 14.3 @ 101.1mph(no traction)
www.cnnmotorsports.com

HOLY SHIT Nice

Those are the rods Shawn Carlson had in his srt-4 block...looks just like mine exept for the awesome rods

BTW what did they use to block the balance shaft feed line? (block filler??) i just gave it a 7mm thread and used a 7mm iron bolt (chopped head, cut grooves for screwdriver...loctite red to make sure it dont think on coming out)

Looking good there though

BTW PM me about SRT oil pan...i really did not wana chop/weld mine...i should have pictures soon of my windage tray/baffle system :)

They use a piece of steel rod and ten just peen the block to prevent it from comming out.

best time so far 14.3 @ 101.1mph(no traction)
www.cnnmotorsports.com

holy shit ya that needs resizing took me like 5 min to dl on cable lol. Nice short block though, i hope the head is equally as impressive. Nice job :eek :bowdown .