Sup guys.
I am going to order this ARP head studs kit from Summit.

http://store.summitracing.com/default.asp?target=esearch.asp&N=100&Ntk=PartSearch&Ntt=141-4202&x=18&y=10

If you click on the link above and go into the ARP head studs item (the only one)

You see the pictures has more then 10 studs, nuts, washer in there.
Is this the correct studs setup for my 420A engine?

BTW, I read many post and search and found out that some people say I need more then one washer on the studs, is this true? is that means the threads are not deep enough on the studs, that's why extra washer is needed?

Thanks again guys.
Gil

those are the ones you need. You don't need an extra washer.

yes that is correct because the hole is to shallow for the bolt to go in and it doesn't hold the head down properly. Many people cut there bolts. The problem area is the set of bolts closest to the firewall and all the way to the right closest to the bat (i believe). Search for HG leak problem.

Originally posted by 420a2ner
yes that is correct because the hole is to shallow for the bolt to go in and it doesn't hold the head down properly. Many people cut there bolts. The problem area is the set of bolts closest to the firewall and all the way to the right closest to the bat (i believe). Search for HG leak problem.

With the correct *STUDS* this is not an issue.

Great... I will order them now.
Thanks again.
Gil

Originally posted by gilee_8
You see the pictures has more then 10 studs, nuts, washer in there.

Yeah, and right below that picture is this text:
Image is a representation of this part. Actual part may vary.

:wary

Never trust the visual representation of a product online.