Just what the title says. I need some input on what you turbo'd 420A veterans that put your own kit together used to tap into your stock oil pressure sensor. I want to be able to totally loose the stock oil sensor, and be able to put a fitting in there that will be compatible with a -4an hose on the other end and maybe have a tapped/threaded side that can be used for an aftermarket oil pressure sending unit. Is this wishful thinking or does one exist? If so where can I get it from or what do I need to make it?

Thanx ahead,
DJ

Plumbing store would be able to get you what you wanted. Just specify the size on both ends you need. The sending unit is only read by the oil dummy light on the dash.

Off hand, would you or somebody know what size fitting and I gues thread type that is going into the block?

Originally posted by DJ420a
Off hand, would you or somebody know what size fitting and I gues thread type that is going into the block?

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=23&topic_id=693&mesg_id=693&listing_type=search

3/8" NPT