Annoying ... its cracked by where the pipe bends to go under the rear wheels ... im seriously pissed .. 650 for a cat back that now could be hammered... ..its rusty and leaking what looks like water or unspent f. i know i need a weld job .. just though i would rant .. anyone else damage their exaust. could my pipe be ruined? its only a slight crack

if its rusty, have your local muffler shop cut out the rusty section as far back untill you hit good metal on either side. then just have them take a section of new pipe, put a slip to slip joint on both ends of the new pipe, slip the new pipe and joints into the old piping, weld the joints in place...wabam...fixed

thank u sir ... im just annoyed its not even 2yrs old !!

Almost all exhausts get condensation in them and leak or blow the water out.

I thought the N1 was made from stainless steel and isn't supposed to rust out????

Yeah I thought they were stainless too until I bought one. It sucks to pay $600 and not even get stainless pipeing. :thumbsdown But at least it sounds good.
Patrick
96 GS
14.14 @ 96.5 mph on 8psi 8 Nov.02
HRC kit, S20G, FMIC, Howell bottom end 8.6 pistons, S-FMU, Blitz BOV, P&P head, SS valves, lots more little goodies

jb weld :cheers

just remove the entire exhaust system. i plan to run an "open" turbo on the neon, lol.

BTW, im just kidding. any muffler shop will fix your problem for not too much $$$.